Maxon WL7-vers. C Manuel de l'opérateur télécharger pdf (Page 60)

PATENTS PENDING

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713

THRESHOLD (MAT) SWITCH ADJUSTMENT (IF REQUIRED)

3. Measure distance from

upper edge of thresh-

old plate to vehicle ﬂ oor

as shown in FIG. 60-3.

Distance should be

1/4” MAXIMUM at any

point across the width of

threshold plate.

LIFT AT GROUND LEVEL

FIG. 60-1

POWER SWITCH

THRESHOLD PLATE INSIDE SLOPE ANGLE 7.1°

FIG. 60-2

2. Set inside slope angle

of threshold plate to 7.1°

MAXIMUM as follows.

Center angle indica-

tor on the inside slope

of threshold plate (FIG.

60-2).

HEIGHT MEASUREMENT

(RH SIDE SHOWN)

FIG. 60-3

1/4”

1. Make sure power switch

is turned on. Lower Lift to

the ground (FIG. 60-1).

THRESHOLD

PLATE

VEHICLE

FLOOR

ANGLE

INDICATOR

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 73 74

Pas de commentaire

Maxon WL7-vers. C Manuel de l'opérateur Page 60